Charger V6-3.5L (2009)
Hydraulic Control Assembly - Antilock Brakes: Removal and Replacement
Hydraulic Control unit (HCU) - Installation
INSTALLATION
To install the HCU, assemble and install the ICU. See: Integrated Control Unit (ICU) - Installation
Integrated Control Unit (ICU) - Removal
REMOVAL
NOTE: Before proceeding, See: Service Precautions/Technician Safety Information See: Service Precautions/Vehicle Damage Warnings .
1. Disconnect and isolate battery negative cable (2) from battery post.
2. Using a brake pedal holding tool, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this position will
isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
3. Remove primary (4) and secondary (1) brake tubes (from master cylinder) at hydraulic control unit (7).
4. Remove remaining brake tubes (2, 3, 5, 6) at hydraulic control unit (7).