Charger V6-3.5L (2009)
4. Install left (2) and right (3) brake tubes at hydraulic control unit (4). Tighten tube nuts to 20 Nm (177 in. lbs.) torque.
5. Install primary (4) and secondary (1) brake tubes at hydraulic control unit (7). Tighten tube nuts to 20 Nm (177 in. lbs.) torque.
6. Remove brake pedal holding tool.
7. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
