Charger V6-3.5L (2009)
1. Take a measurement across the upper edge (2) of the rear glass using the vertical edges of the body opening as the reference points.
2. Divide the upper measurement in half and mark that dimension on the glass using a grease pencil or equivalent. This is the upper centerline of the
glass.
3. Take a measurement across the lower edge (1) of the glass using the vertical edges of the body opening as the reference points.
4. Divide the lower measurement in half and mark that dimension on the glass using a grease pencil or equivalent. This is the lower centerline of the
glass.
5. Connect the top center mark and the lower center mark and mark a straight line (3) for the center of the glass.
SET UP AIM BOARD AND TRIPOD
AIMING BOARD SET UP FOR ACC