Charger V6-3.5L (2009)
Cruise Control Switch: Service and Repair
Speed Control Switch - Removal
Adaptive Cruise Control/Standard Passenger Speed Control Switch
ADAPTIVE CRUISE CONTROL/STANDARD PASSENGER SPEED CONTROL SWITCH
WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to electrical restraint system for service
procedures. See: Restraint Systems/Service and Repair Failure to do so may result in accidental deployment of the airbag and
possible serious personal and/or fatal injury may result.
NOTE: Position the front wheels straight-ahead.
1. Disconnect and isolate the negative battery cable before beginning steering wheel removal. Allow the front airbag system capacitor to discharge
for two minutes before removing the steering wheel or any front airbag system component.
2. Remove the driver airbag (3), See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Air Bag - Removal.
3. Disconnect electrical connector (2) from speed control switch (3).
4. Remove front screw (1) from speed control switch (3).
WARNING: The Adaptive Cruise Control Switch and Standard Passenger style Speed Control Switch are mounted identically, have
similarities in appearance but function differently. Make sure the vehicle is equipped with either the Standard Passenger style
Speed Control System or Adaptive Cruise Control System and ONLY replace with the correct switch during removal and
installation procedures. If the Standard Passenger style Speed Control Switch is used to replace an Adaptive Cruise Control
switch, then the "Distance Function" of the Adaptive Cruise Control System WILL NOT work, and the system will work as a
Standard Speed Control equipped vehicle. The driver will not know that the "Distance Function" of the Active Cruise Control
System is not functioning and this could lead to personal and/or fatal injury.
5. Remove rear screws (1) from speed control switch (2).
6. Remove speed control switch (2) from steering wheel.
