Charger V6-3.5L (2009)
2. To replace spark plug tube seals (2):
a. Using a suitable pry tool, carefully remove tube seals (2).
b. Position new seal (2) with the part number on seal facing cylinder head cover.
c. Install seals using Camshaft Installer MD-998306 (1).
3. Install cylinder head cover and bolts. Tighten bolts to 12 Nm (105 in. lbs.).
4. Install the ground strap retaining bolt (3) to the cylinder head cover.
5. Install the wire harness track (4).
6. Install the ignition coils (2). Tighten mounting screws to 6.7 N.m (60 in. lbs.) See: Powertrain Management/Ignition System/Ignition Coil/Service
and Repair/Ignition Coil - Installation.
7. Connect the ignition coil electrical connectors (2).
8. Install upper intake manifold See: Intake Manifold/Service and Repair/Intake Manifold - Installation.
9. Connect negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
