Charger V6-3.5L (2009)
8. Position the rear belly pan (2) to the underside of the vehicle.
9. Install the fasteners (1) that secure the rear belly pan to the underside of the vehicle.
10. Lower the vehicle.
11. Connect the negative battery cable.
Insulator, Engine Mount, AWD
INSTALLATION
1. Carefully position the engine mount and hand tighten the mount retaining bolts.
2. Tighten the engine mount to bracket bolts to 60 Nm (44 lbs. ft.).
3. Lower the engine onto the cradle and remove the jack stand.
4. Tighten the engine mount to cradle bolt to 75 Nm (55 lbs. ft.).
5. Install the right front wheel.
6. Lower the vehicle.
7. Connect the negative battery cable.
