Charger V6-3.5L (2009)
Air Door Actuator / Motor: Service and Repair
Blend Door Actuator - Installation
INSTALLATION
NOTE: The single zone heater-A/C system is equipped with a single blend door actuator. The dual zone system has two blend door actuators,
one for the driver side blend-air door and one for the passenger side blend-air door.
NOTE: LHD model shown in illustrations. RHD model similar.
SINGLE ZONE/DUAL ZONE DRIVER SIDE
1. Position the blend door actuator (1) into the vehicle.
2. Install the blend door actuator onto the driver side of the HVAC air distribution housing (4). If necessary, rotate the actuator slightly to align the
splines on the actuator output shaft (2) with those on the blend door cam (3).
3. Install the two screws (4) that secure the blend door actuator (1) to the air distribution housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
4. Connect the HVAC wire harness connector (2) to the blend door actuator.
5. If equipped, install the instrument panel silencer onto the driver side of the instrument panel See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Silencer Panel - Installation.
6. Reconnect the negative battery cable.
7. Initiate the Actuator Calibration function using a scan tool . See: Testing and Inspection/Component Tests and General Diagnostics/Heating and
Air Conditioning/Heating and A/C Systems
DUAL ZONE PASSENGER SIDE
