Charger V6-3.5L (2009)
Air Duct: Service and Repair
Defroster Duct - Removal
REMOVAL
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the
airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag
system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage.
NOTE: LHD model shown. RHD model similar.
1. Remove the instrument panel and place it on a workbench See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Instrument Panel - Removal.
2. Remove the four screws (1) that secure the defroster duct (2) to the top of the HVAC air distribution housing (3) and remove the duct.
Defroster Duct - Installation
INSTALLATION
NOTE: LHD model shown. RHD model similar.
1. Position the defroster duct (2) onto the top of the HVAC air distribution housing (3).
2. Install the four screws (1) that secure the defroster duct to the air distribution housing. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
