Charger V6-3.5L (2009)
panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag
system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure
to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage.
NOTE: LHD model shown in illustrations. RHD model similar.
FRONT FLOOR DISTRIBUTION DUCT
1. Remove the HVAC air distribution housing See: Housing Assembly HVAC/Service and Repair/Removal and Replacement/HVAC Housing -
Removal.
2. Remove the six screws (1) that secure the front floor distribution duct (2) to the bottom of the air distribution housing (3) and remove the duct.
INTERMEDIATE FLOOR DISTRIBUTION DUCTS
1. Remove the center floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Removal.
2. Remove the front seats See: Body and Frame/Seats/Service and Repair/Seat, Front/Seat - Removal.
3. Roll back the front floor carpet from under the instrument panel toward the rear of the vehicle See: Body and Frame/Interior Moulding /
Trim/Carpet/Service and Repair/Carpet - Removal.
4. Remove the push pin fastener that secures the passenger side front intermediate floor distribution duct (2) to the floor support (4).
5. Disconnect the passenger side front intermediate floor distribution duct (2) from the front floor distribution duct (1).
6. Disconnect the passenger side front intermediate floor distribution duct (2) from the passenger side rear intermediate floor distribution duct (3).
7. Remove the passenger side rear intermediate floor distribution duct (3) from the floor support (4).
8. Remove the push pin fastener that secures the driver side rear intermediate floor distribution duct (5) to the floor support (4).
9. Disconnect the driver side front intermediate floor distribution duct (6) from the front floor distribution duct (1).
10. Disconnect the driver side front intermediate floor distribution duct (6) from the driver side rear intermediate floor distribution duct (5).
11. Remove the driver side rear intermediate floor distribution duct (5) from the floor support (4).
