Charger V6-3.5L (2009)
Control Assembly: Service and Repair
A/C and Heater Control - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: ATC A/C-heater controls are NOT interchangeable between other model years or other vehicle lines. If replacement of the A/C-heater
control is required, only use the control designed for the vehicle being serviced.
NOTE: Take the proper precautions to protect the front face of the instrument panel center bezel from cosmetic damage during this service
procedure.
1. Disconnect and isolate the negative battery cable.
2. Remove the center bezel (1) from the instrument panel (2), disconnect the wire harness connector(s) (3) from the A/C-heater control (4) and place
the center bezel on a workbench See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel Bezel - Removal.
3. Remove the four screws (1) that secure the A/C-heater control (2) to the instrument panel center bezel (3).
4. Remove the A/C-heater control from the instrument panel center bezel.
