Charger V6-3.5L (2009)
4. If equipped with dual zone heating-A/C, disconnect the HVAC wire harness (4) from the blend door actuator (2) located on the passenger side of
the air distribution housing (3).
5. On LHD models, remove the blend door actuator (1) from the driver side of the HVAC air distribution housing (2) See: Air Door/Air Door
Actuator / Motor/Service and Repair/Blend Door Actuator - Removal.
6. Remove the two screws (8) that secure the flange (7) to the front of the HVAC housing near the dash panel and remove the flange.
7. Remove the screw (5) that secures the heater core retaining bracket (3) to the driver side of the HVAC air distribution housing and remove the
bracket.
8. Disengage the heater core tubes (6) from the HVAC housing and carefully pull the heater core (4) straight out of the side of the air distribution
housing.
9. Remove the two screws (1) that secure the air distribution housing (2) to the rear of the HVAC housing (3).
10. Tilt the top of the air distribution housing rearward to disconnect the distribution housing from the tab-and-slot type retainers located at the bottom
of the housing.
11. Disconnect the air distribution housing from rear floor distribution ducts.
12. Remove the air distribution housing from the vehicle.
13. If required, disassemble the air distribution housing See: Overhaul/Disassembly.
Air Distribution Housing Installation
HOUSING-AIR DISTRIBUTION
WARNING: The heater core tubes are not serviced separately from the heater core. The heater core tubes should not be repositioned, loosened
or removed from the heater core. Failure to follow these instructions may result in a coolant leak and possible serious or fatal
injury.
NOTE: LHD model shown in illustrations. RHD model similar.
