Charger V6-3.5L (2009)
9. If equipped with dual zone heating-A/C, connect the HVAC wire harness (4) to the blend door actuator (2) located on the passenger side of the air
distribution housing (3).
10. Connect the HVAC wire harness (1) to the mode door actuator (2) and the blend door actuator (3) located on the driver side of the air distribution
housing (4).
11. Install the HVAC housing assembly See: HVAC Housing - Installation
12. Reconnect the negative battery cable.
13. If the heater core is being replaced, flush the cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
14. Refill the engine cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
15. Evacuate and charge the refrigerant system See: Service and Repair/Refrigerant System Charge.
Air Inlet Housing Removal
HOUSING-AIR INLET
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution . Failure to follow the warnings and cautions could result in possible
personal injury or death.
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the
airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag
system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
