dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Fuel Pump Module - Removal|Page 10214 > < Fuel Pump Module - Removal|Page 10212
Page 7
background image

16. Push the rear lower seat cushion back and down and install the seat cushion.
17. Connect the negative battery cable.
18. Fill the fuel tank and check for leaks.

Removal - Left

LEFT SIDE MODULE

1. Release the fuel pressure, refer to the Fuel Pressure Release Procedure.
2. Disconnect negative battery cable.

NOTE: The fuel level of the vehicle must be below 5/8 of a tank before you remove the module lock-rings. If it is above that you can spill fuel

in the vehicle.

3. Drain partial fuel from fuel tank through the filler tube. Use a hard nylon tube, with a 30° cut on the end, to push the check valve open to drain fuel

from tank.

Fuel Pump Module - Removal|Page 10214 > < Fuel Pump Module - Removal|Page 10212