Charger V6-3.5L (2009)
Fuel Level Sensor: Service and Repair
Right Side Module - Removal
RIGHT SIDE MODULE
1. Release the fuel pressure, refer to the Fuel Pressure Release Procedure See: Fuel Delivery and Air Induction/Fuel Filter/Fuel Pressure
Release/Service and Repair.
2. Disconnect negative battery cable.
NOTE: The fuel level of the vehicle must be below 5/8 of a tank before you remove the module lock-rings. If it is above that you can spill fuel
in the vehicle.
3. Drain partial fuel from fuel tank through the filler tube. Use a hard nylon tube, with a 30° cut on the end, to push the check valve open to drain fuel
from tank.
4. Remove the rear lower seat cushion.
