Charger V6-3.5L (2009)
3. Position the PCM and bracket to the vehicle.
NOTE: Prior to reconnecting the electrical connectors to the PCM, check the pins in the electrical connectors for misalignment and/or
damage. Repair as necessary.
4. Connect the electrical connectors to the PCM.
5. Install the bolt that secures the PCM bracket to the cross support. Tighten the bolt to 9 Nm (80 in. lbs.).
6. Install the cowl panel cover See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair/Cowl Panel Cover - Installation.
7. Reconnect the negative battery cable.
NOTE: If a new PCM is installed, it must be programed with the original Vehicle Identification Number (VIN) and mileage. If this is not
done, a Diagnostic Trouble Code (DTC) may set.
8. If a new PCM is being installed, use a scan tool and program the new PCM with the original VIN and vehicle mileage.