Charger V6-3.5L (2009)
Fuel Level Sensor: Service and Repair
Fuel Pump Module - Removal
REMOVAL
WARNING: The fuel system may be under a constant pressure (even with the engine off). Before servicing the fuel pump module, the fuel
system pressure must be released.
1. Perform the fuel pressure release procedure as follows:
-
For gas engines See: Fuel Delivery and Air Induction/Fuel Filter/Fuel Pressure Release/Service and Repair
-
For diesel engine See: Fuel Delivery and Air Induction/Fuel Filter/Fuel Pressure Release/Service and Repair
NOTE: The fuel level of the vehicle must be below 5/8 of a tank before you remove the module lock-rings. If it is above that level you can spill
fuel in the vehicle.
2. Partially drain the fuel tank, perform the fuel tank draining procedure as follows:
-
For gas engines . See: Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Procedures
-
For diesel engine . See: Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Procedures
3. Disconnect the negative battery cable.
4. Push the rear lower seat cushion up and back and remove the seat cushion.
5. Fold back the foam pad covering the fuel pump module rubber access plugs.
