Charger V6-3.5L (2009)
2. Remove the fuel pump module and inspect the fuel inlet strainer for damage or a condition that might cause a fuel flow problem.
Were any problems found?
Yes
-
Replace the Fuel Pump Inlet Strainer.
-
Perform the PCM Verification Test. See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Verification Tests/PCM Verification Test
No
-
Replace the Fuel Pump Module.
-
Perform the PCM Verification Test. See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Verification Tests/PCM Verification Test
7. FUEL PUMP GROUND CIRCUIT OPEN OR HIGH RESISTANCE
1. Turn the ignition off.
2. Disconnect the Fuel Pump Module harness connector.
3. Using a 12 volt test light connected to 12 volts, check the Fuel Pump Motor Ground circuit at the Fuel Pump Module harness connector.
NOTE: The test light should be illuminated and bright. Compare the brightness to that of a direct connection to the battery.
Is the test light illuminated and bright?
Yes
-
Replace the Fuel Pump Module.
-
Perform the PCM Verification Test. See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Verification Tests/PCM Verification Test
No
-
Repair the Fuel Pump Ground circuit for an open circuit or high resistance.
-
Perform the PCM Verification Test. See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Verification Tests/PCM Verification Test
