Charger V6-3.5L (2009)
6. Position the upper turning loop (3) and install the retaining bolt (4). Torque bolt to 40 Nm (30 ft. lbs.).
7. Install the upper turning loop (3) trim cover (2).
8. Install the lower B-pillar trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/B-Pillar Trim
Panel-Installation.
9. Position the seat belt (1) onto the stud on the seat cushion frame and install the lower anchor nut (2). Torque nut to 37 Nm (27 ft. lbs.).
10. Install the trim cover (3) onto the seat cushion outboard trim cover.
WARNING: Do not connect the battery negative cable See: Testing and Inspection/Component Tests and General Diagnostics . Personal injury or
death may result if the system test is not performed first.