Charger V6-3.5L (2009)
7. If installing left sensor, clip sensor cable (3) to routing clip near body connector (1).
8. Match left sensor connector (4) to right sensor connector (3) to make one connector.
9. Insert sensor connectors (3 and 4) into body wiring harness connector (1) located in luggage compartment floor pan (2). When installing
connector, make sure retaining clip on body connector is properly in place and sensor connector cannot be pulled out.
10. Lower vehicle.
11. Perform Verification Test and clear any faults See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests.
