Charger V6-3.5L (2009)
Starter Motor: Service and Repair
Starter - Removal
3.5L
NOTE: All Wheel Drive procedure shown. Rear Wheel Drive Similar.
1. Disconnect and isolate negative battery cable at battery.
2. Remove the left side catalytic converter (4), See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair/Catalytic
Converter - Removal.
3. Remove battery cable nut (5) and battery cable (4) from solenoid stud (2).
4. Disconnect electrical connector (3) from starter solenoid terminal (1).