Charger V6-3.5L (2009)
3. Manual tilt and telescoping columns - Position the manual adjustment handle (2) over the column adjustment pin and rotate the locking tab (3)
rearward as shown latching the handle to the column. Make sure the tab snaps into locked position.
4. Install the cluster bezel (3) See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Cluster
Bezel - Installation
5. Install the steering column opening reinforcement (1)
6. Install the steering column opening cover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Steering Column Opening Cover - Installation
7. Install the steering column control module (SCCM) (1) and all components removed to access it. See: Relays and Modules - Steering/Steering
Mounted Controls Communication Module/Service and Repair/Removal and Replacement/Steering Column Control Module - Installation
8. Install the negative battery terminal on the battery. It is important that this is performed properly (including calibration of steering angle sensor if
equipped with ESP). See: Starting and Charging/Battery/Service and Repair/Procedures/Battery Reconnection
9. Test the operation of the horn, lights and any other functions that are steering column operated
