Charger V6-3.5L (2009)
NOTE: Prior to using Press (1), Special Tool C-4212F Ball Joint Press Installer/Removal, lubricate screw-drive threads to provide ease of use
and promote tool longevity.
36. Assemble tools (See following list) over bushing as shown. Ensure Remover lies between ridges (3) on bushing to properly contact bushing can.
-
(1) Press C-4212F
-
(2) Remover 9031-5A
-
(4) Receiver 9031-8A
37. Tighten Press (1) screw-drive, pressing bushing out of crossmember.
38. Remove all tools.
Rear Mount
REMOVAL
1. Disconnect and isolate battery negative cable (2) from battery post.
2. Raise and support vehicle. See: Wheels and Tires/Vehicle Lifting/Service and Repair
