Charger V6-3.5L (2009)
32. Insert Brace (1), Special Tool 9031-12, between Support 9031-11 (3) and bushing bore flange (2) matching angle cut in Brace to bore flange.
33. Snug set-screws (1) against Brace 9031-12. Do not overtighten set-screws as they will distort and bend bushing bore flange.
NOTE: Prior to using Press (1), Special Tool C-4212F, lubricate screw-drive threads to provide ease of use and promote tool longevity.
34. Assemble tools (See following list) over bushing as shown.
-
(1) Press C-4212F
-
(2) Remover 9031-2
-
(3) Receiver 9031-1
35. Tighten Press (1) screw-drive, pressing bushing out of crossmember.
36. Remove all tools.
Spring Link
REMOVAL
1. Raise and support vehicle. See: Wheels and Tires/Vehicle Lifting/Service and Repair
2. Access and remove rear spring on side of repair. See: Suspension Spring ( Coil / Leaf )/Service and Repair/Rear Suspension - Coil Spring(s) -
Removal
