Charger V6-3.5L (2009)
Front Steering Knuckle: Service and Repair
Disassembly
BALL JOINT
NOTE: To perform this procedure, it works best to mount Ball Joint Press C-4212F in a vise.
1. Place Ball Joint Remover/Installer 9320 (1) into cup area of Ball Joint Press C-4212F (3) as shown and tighten set screw.
2. Place Ball Joint Remover/Installer 9320-3 (2) onto end of screw-drive of Ball Joint Press C-4212F (3) as shown.
3. Using a pair of snap-ring pliers (2), remove snap-ring (3) from bottom of ball joint (1).