Charger V6-3.5L (2009)
5. Remove nut (2) fastening stabilizer link (3) to shock assembly (1). Slide link ball joint stem from shock assembly.
6. Remove bolt (3) securing shock assembly (1) to lower control arm (4).
7. Disconnect wheel speed sensor cable routing clip (2) at brake tube bracket (3).
8. Loosen nut (4) attaching upper ball joint stud (1) to knuckle. Back nut off until nut is even with end of stud. Keeping nut on at this location will
help keep end of stud from distorting while using Puller in next step.
