Charger V6-3.5L (2009)
NOTE: Always install a new hub nut. The original hub nut is one-time use only and should be discarded when removed.
4. Install hub nut (1) on end of axle half shaft (2). While a helper applies brakes to keep hub from turning, tighten hub nut to 213 Nm (157 ft. lbs.)
torque.
5. Install tire and wheel assembly (1) See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation. Tighten
wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) torque.
6. Lower vehicle.
7. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
8. Check and adjust brake fluid level in reservoir (1) as necessary.
9. Road test vehicle and make several stops to wear off any foreign material on brakes and to seat brake pads.
