Charger V6-3.5L (2009)
5. Stake the output shaft nut to the output shaft as follows.Place the Staking Tool 9078 (2) and Driver Handle C-4171 onto the output shaft.
6. Rotate the Staking Tool 9078 (2) until the alignment pin (3) engages the output shaft notch (4).
7. Press downward on the staking tool until the staking pin (3) contacts the output shaft nut flange (2).
8. Strike the Driver handle C-4171 with a suitable hammer until the output shaft nut is securely staked to the output shaft.
9. Install the propeller shaft See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Propeller Shaft - Installation.
Torque Converter Hub Seal - Removal
REMOVAL
1. Remove the torque converter See: Torque Converter/Service and Repair/NAG1 Automatic Transmission/Torque Converter - Removal.
2. Remove the torque converter hub seal with suitable screw and slide hammer.
Torque Converter Hub Seal - Installation
INSTALLATION
1. Position the torque converter hub seal (1) over the input shaft and against the transmission oil pump.
