Charger V6-3.5L (2009)
Transmission Speed Sensor: Service and Repair
Input Speed Sensor - Installation
INSTALLATION
1. Install the input speed sensor (1) into the transmission case.
NOTE: Before installing the speed sensor bolt, it will be necessary to replentish the sealing patch on the bolt using Mopar(R) Lock & Seal
Adhesive.
2. Install the bolt to hold the input speed sensor (1) into the transmission case. Tighten the bolt to 9 Nm (80 in.lbs.).
3. Install the wiring connector onto the input speed sensor
4. Verify the transmission fluid level. Add fluid as necessary. . See: Automatic Transmission/Transaxle/Fluid - A/T/Service and Repair/NAG1
Automatic Transmission/Check Oil Level
5. Lower vehicle.