Charger V6-3.5L (2009)
Back Window Glass: Service and Repair
Backlite - Installation
INSTALLATION
CAUTION: To help prevent water leaks, partially roll down the left and right door glass before installing the backlite. This avoids pressurizing
the passenger compartment if a door is slammed before the urethane is cured.
CAUTION: Protect all painted and trimmed surfaces from coming in contact with urethane or primers.
1. If the backlite (1) is being reused, remove the as much original urethane (3) as possible from the glass surface using a razor knife (2).
NOTE: To prevent corrosion, do not damage paint on the backlite fence when removing original urethane.
NOTE: The backlite fence should be cleaned of most of its old urethane adhesive. A small amount of old urethane, approximately 1 mm in
height should remain on the fence. Do not completely remove all old urethane from the fence, the paint finish and bonding strength
will be adversely affected. Replace any missing or damaged spacers around the perimeter of the backlite fence.
2. Using a razor knife (2), level the original bead of urethane (1) on the backlite fence (3) to a thickness of approximately 1 mm (0.04 in.) and
remove the loose adhesive.
