Charger V6-3.5L VIN G (2006)
10.
Remove both of the old deck lid inner bumpers from the deck lid (Fig. 3).
11.
Install two (2) new deck lid inner bumpers on the deck lid (Fig. 3).
12.
Remove both of the old fascia over-slam bumper assemblies (Fig. 4).
NOTE:
Use a small flat-head screwdriver to remove pushpin.
13.
Install two (2) new fascia bumper assemblies (Fig. 4).
14.
Close and open the deck lid five (5) times to adjust the system.
15.
Rub out or spot repair the rear fascia paint surface and deck lid edge as necessary.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
