Charger V6-3.5L VIN G (2006)
Headliner: All Technical Service Bulletins
Interior - Headliner Sags in Rear
NUMBER: 23-043-05
GROUP: Body
DATE: September 21, 2005
THIS BULLETIN IS BEING PROVIDED IN ADVANCE. DO NOT ORDER PARTS OR PERFORM ANY ACTIONS RELATED TO THIS
BULLETIN UNTIL OCTOBER 05, 2005.
SUBJECT:
Headliner Fit At Backlight
OVERVIEW:
This bulletin involves replacing hook and loop fasteners and if necessary a magnet at the rear of the headliner.
MODELS:
2005 - 2006
(LX)
300/Charger
SYMPTOM/CONDITION:
Headliner sags at rear adjacent to backlight.
DIAGNOSIS:
If a vehicle operator has a concern with the headliner sagging or hanging down in rear, or if visual inspection shows obvious sag, inspect the rear
headliner attachments. Fit/finish attachments are located near the rear edge of the headliner, approximately 5 inches forward of headliner rear edge. The
Charger rear edge is secured with 2 hook & loop patches and one center magnet. The magnet housing may crack at the snap-tab fingers to magnet due to
embrittlement of the base polycarbonate resin. The 300 rear edge is secured with a plastic cross-car locator/attachment above the left rear passenger and
with a hook & loop fastener above the right rear passenger. If any one of these attachments fail, the headliner rear trim edge may sag and become flimsy
to the touch. Gently grab and lower the rear trim edge and feel with your fingers for the respective left, center or right attachments for obvious issues. If
any headliner attachment failure is discovered, Perform the Repair Procedure.
PARTS REQUIRED:
REPAIR PROCEDURE:
1.
Fold the rear seat backs down if the vehicle is so equipped.
NOTE:
Do not pull the headliner down more than necessary to maintain separated attachments. Doing so may crease, crack, or otherwise damage headliner.
