Charger V6-3.5L VIN G (2006)
2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
NOTE: In some cases, it may be necessary to retract caliper piston in its bore a small amount in order to provide sufficient clearance between
shoes and rotor to easily remove caliper from knuckle. This can usually be accomplished before guide pin bolts are removed, by grasping rear of
caliper and pulling outward working with guide pins, thus retracting piston. Never push on piston directly as it may get damaged.
3. Remove two bolts (1) securing disc brake caliper adapter (3) to knuckle (2).
4. Remove disc brake caliper and adapter (3) from knuckle as an assembly. Hang assembly out of way using wire or a bungee cord. Use care not to
overextend brake hose when doing this.
5. Remove any clips (2) retaining brake rotor (3) to wheel mounting studs.
6. Slide brake rotor (3) off hub and bearing (1).
INSTALLATION
FRONT
NOTE: Inspect brake pads before installation.
1. Clean hub face (1) to remove any dirt or corrosion where rotor mounts.
