Charger V6-3.5L VIN G (2006)
5. Disconnect wiring harness (6) connector from brake fluid level sensor (2) in master cylinder brake fluid reservoir (1).
NOTE: SRT8 vehicles are not equipped with a master cylinder mounted pressure switch for the Electronic Stability Program. The switch is
located in the primary brake tube.
6. If equipped with Electronic Stability Program (non-SRT8), disconnect wiring harness (6) connector from pressure switch (5).
7. Disconnect primary (3) and secondary (2) brake tubes from master cylinder (4). Install sealing plugs in open brake tube outlet ports.
CAUTION: Before removing master cylinder from power brake vacuum booster, master cylinder and vacuum booster must be thoroughly
cleaned. This must be done to prevent dirt particles from failing into power brake vacuum booster. Use only Mopar® Brake Parts Cleaner or
equivalent.
8. Remove two nuts (1) attaching master cylinder to power brake booster.
9. Slide master cylinder straight out of power brake booster.
