Charger V6-3.5L VIN G (2006)
Piston Ring: Procedures
Piston Ring Fitting
STANDARD PROCEDURE - PISTON RING FITTING
1. Wipe cylinder bore clean. Insert ring and push down with piston to ensure it is square in bore. The ring gap measurement must be made with the
ring positioning at least 12 mm (0.50 inch) from bottom of cylinder bore. Check gap with feeler gauge.
2. Check piston ring to groove clearance.
Piston Ring - Removal and Installation
PISTON RING
REMOVAL
1. Remove piston and connecting rod.
2. Remove No. 1 and No.2 piston rings from piston using a ring expander tool.
