Charger V6-3.5L VIN G (2006)
NOTE: Assure that the rear face of the oil pan is flush to the transmission bell housing when installing the oil pan.
5. Pre-torque the horizontal rear oil pan to transmission bolts to 1.4 Nm (12 inch lbs.).
6. First tighten the M8 (1) oil pan alignment bolt to 28 Nm (250 inch lbs.), then tighten bolt (2) to 28 Nm (250 inch lbs.).
7. Tighten the remaining M8 bolts and M8 nuts to 28 Nm (250 inch lbs.), and the M6 bolts to 12 Nm (105 inch lbs.).
8. Tighten the four M10 oil pan to transmission bolts to 55 Nm (40 ft. lbs.).
9. Lower the engine and remove the lifting fixture. Tighten the engine mount to cradle fasteners to 75 Nm (55 ft. lbs.).
10. Install the flex plate inspection cover (1) and tighten the fastener (2) to 11 Nm (97 inch lbs.).
11. Install the oil cooler (align the oil cooler notch to oil pan tab).
12. Install the engine oil filter. Tighten filter to 12 Nm (106 inch lbs.).
