Charger V6-3.5L VIN G (2006)
6. Remove muffler and tailpipe assembly (5) by twisting/turning while pulling assembly out of catalytic converters.
INSTALLATION
1. Position front exhaust pipe module clamps (2) on exhaust pipe assembly
2. Install exhaust pipe assembly into catalytic converters (3 and 4).
NOTE: Isolators will have an approximately 100 forward angle when installed.
3. Install isolators.
4. 5.7L/6.1 L Engine - Install LH rear resonator and tailpipe assembly.
NOTE: Check for proper alignment and clearance to underbody and engine compartment components before tightening clamps.
5. Tighten band clamps to 61 Nm (45 ft. lbs.).
