Charger V6-3.5L VIN G (2006)
5. Install the screws (4) that secure the two halves of the air distribution housing (3) together. Tighten the screws to 2.2 N.m (20 in. lbs.).
6. Inspect the foam seal (1), especially at the parting line (2). If the seal is deformed or damaged, it must be replaced.
7. Position the front floor distribution duct (2) onto the air distribution housing (3).
8. Install the six screws (1) that secure the front floor distribution duct to the air distribution housing. Tighten the screws to 2 N.m (17 in. lbs.).
9. If equipped with dual zone heating-A/C, install the blend door cam (1) onto the blend door lever (2) and the pivot shaft located on the passenger
side of the air distribution housing (3).
