Charger V6-3.5L VIN G (2006)
4. Remove the two nuts (2) holding the seat weight sensor (4) to the seat riser.
5. Disconnect the one electrical connector (1).
INSTALLATION
NOTE: If the vehicle is equipped with a power front passenger seat, to remove the adjuster from the riser it is necessary to have battery power to move
the seat forward and rearward to access the mounting bolts.
1. Position the seat weight sensor onto passenger front seat riser.
2. Install the two nuts (2) holding the seat weight sensor (4) to the seat riser. Torque nuts to 40 N.m (30 ft. lbs.).
3. Connect the one electrical connector (1).