Charger V6-3.5L VIN G (2006)
25. Tighten fasteners at knuckle (vehicle at curb height) as follows:
^
Camber Link (1) - 98 Nm (72 ft. lbs.) torque.
^
Compression Link (5) - 81 Nm (60 ft. lbs.) torque.
^
Stabilizer Link - 61 Nm (45 ft. lbs.) torque.
^
Tension Link (6) - 98 Nm (72 ft. lbs.) torque.
^
Toe Link (3) - 81 Nm (60 ft. lbs.) torque.
26. Perform wheel alignment.
KNUCKLE - SRT8
1. Install four hub mounting bolts through knuckle from inboard side allowing ends to protrude from opposite side.
2. Position knuckle on vehicle and install bolt and nut fastening camber link (1) to knuckle (4) as shown. Do not tighten bolt at this time.
3. Install bolt and nut fastening tension link (6) to knuckle (4) as shown. Do not tighten bolt at this time.
4. Install bolt and nut fastening stabilizer link to knuckle (4). Do not tighten bolt at this time.
5. Install bolt fastening toe link (3) to knuckle (4). Do not tighten bolt at this time.
6. Install bolt and nut fastening compression link (5) to knuckle (4). Do not tighten bolt at this time.
NOTE: If a new knuckle sleeve is not installed in knuckle, perform Step 7 through Step 11.
