Charger V6-3.5L VIN G (2006)
7. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
8. Fill pump reservoir with fluid and perform pump initial operation procedure.
GEAR TO COOLER - AWD
1. Route cooler end of return hose (3) over stabilizer bar from rear using the reverse of how it was removed.
NOTE: Always use a NEW O-ring on the end of the return hose at the steering gear.
2. Lubricate NEW O-ring on steering gear end of return hose with clean power steering fluid.
3. Lift gear end of return hose to return port on steering gear. Install return hose (2) to steering gear (1). Do not tighten tube nut at this time.
