Charger V6-3.5L VIN G (2006)
8. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
9. Fill pump reservoir with fluid and perform pump initial operation procedure.
5.7L/6.1L ENGINE
1. Align pump (1) with mounting holes on engine.
2. Install three pump mounting bolts (2) through access holes in pulley Tighten bolts to 28 Nm (21 ft. lbs.) torque.
NOTE: Always use a NEW O-ring on the end of the pressure hose.
3. Lubricate NEW O-ring on end of pressure hose with clean power steering fluid.
