Charger V6-3.5L VIN G (2006)
NOTE: Due to axle imbalance concerns, it is necessary to make sure pinion flange-to-shaft orientation is maintained. If alignment marks are not
visible, apply appropriate marks before removing pinion flange.
4. Using puller 1026 (1), remove pinion flange (2) from pinion shaft.
5. Using suitable tool (1), remove pinion seal (2) and discard.
INSTALLATION
1. Apply light coating of gear lubricant to the lip of the pinion seal.
2. Using Tool 9231A (1), install pinion seal until tool bottoms on carrier.
