Charger V6-3.5L VIN G (2006)
5. Remove four bolts (3) fastening hub and bearing (2) to knuckle.
6. Slide hub and bearing (2) off axle half shaft (1) and knuckle.
RWD
1. Raise and support vehicle.
2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
3. Access and remove front brake rotor.
4. Remove dust cap (2). When doing this, avoid damaging internal bore of hub to preserve seal integrity.
5. Remove hub nut (1).
6. Slide hub and bearing off knuckle spindle.
INSTALLATION
AWD