Charger V6-3.5L VIN G (2006)
3.
Remove the protective coating from the adhesive on the reinforcement clip install the clip on to the bottom of the run channel as shown (Fig. 1).
Hook the short straight side of the reinforcement clip on to the channel on the side closest to the outer door skin and snap the curved end on to the
inside of the channel. The reinforcement clip should be as close to the bottom of the run channel as possible.
4.
Install the water shield and door trim panel.
5.
Repeat the process to install the reinforcement clip on to the other front door glass channel.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
