Charger V8-5.7L (2008)
Rear Bumper Cover / Fascia: Service and Repair
Rear Fascia - Installation
INSTALLATION
1. If removed, install the two push-pin retainers (2) and a new nut insert (1) into each quarter panel.
NOTE: 300 Shown. Magnum and Charger similar.
2. If removed on SRT8 models, install the lower fascia onto the rear fascia assembly (6) using new metal retaining clips.
3. If equipped and removed, install the park assist sensors into the rear fascia assembly See: Accessories and Optional Equipment/Collision
Avoidance and Parking Assist Systems/Parking Assist Distance Sensor/Service and Repair/Park Assist Sensor - Installation.
4. Position the rear fascia assembly to the vehicle and connect the license plate lamp and park assist wire harness connector (4), if equipped.
5. Engage the two push-pin retainers (2) into the two slots (3) in each side of the rear fascia assembly by pushing the fascia forward.
6. Install the push-pin retainers (5) (three-sedan, three-wagon, one-charger) that secure the rear fascia assembly to the decklid sill.
7. On sedan models, install the two bumper stops (1).
