Charger V8-5.7L (2008)
46. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
47. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
48. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access mounting bolts.
49. Tighten shock absorber lower mounting bolt nuts (4) to 72 Nm (53 ft. lbs.).
50. Tighten compression link bolt and nut (1) at crossmember to 85 Nm (63 ft. lbs.).
51. Perform wheel alignment, paying special attention to thrust angle. If rear crossmember needs to be shifted to align thrust angle, try to avoid
compromising tension link clearance (Refer to STEP 23). See: Maintenance/Alignment/Service and Repair
Rear Mount
INSTALLATION