Charger V8-5.7L (2008)
1. Position the rear carpet (3) into the vehicle through one of the rear door openings.
2. Pull the body wire harness take outs and connectors through the appropriate slits in the rear carpet.
3. Fit the rear carpet to the floor panel. Be certain to align the holes in the carpet with the corresponding holes in the floor panel. Be certain that the
rear edge of the carpet is fitted over the rear seat kick-up area and over the rear seat cushion cups on the top of the kick-up area. Be certain that the
front edge of the carpet is fitted over the front seat rear crossmember and butts up against the rear of the front seat front crossmember.
4. Install the push-pin fasteners (2) that secure the outboard edges of the rear carpet near the front of each rear door opening (1) sill.
5. Reinstall the scuff plate onto both rear door sills. See: Scuff Plate/Service and Repair/Door Sill Scuff Plate/Door Sill Scuff Plate - Installation.
6. Reinstall the rear seat cushion into the vehicle. See: Seats/Seat Cushion/Service and Repair/Seat Cushion / Cover - Installation.
7. Reinstall the trim onto the inside of both lower B-pillars. See: Trim Panel/Service and Repair/Pillar Trim/B-Pillar Trim.
8. Reinstall the center console onto the front floor panel transmission tunnel. See: Console/Service and Repair/Floor Console - Installation.
9. Reinstall the driver and passenger front seats into the vehicle. See: Seats/Service and Repair/Seat - Installation.
Trunk - Sedan
TRUNK - SEDAN
1. Fold the spare tire cover/trunk floor carpet (1) and place it within the luggage compartment.
2. Unfold, position and fit the spare tire cover/trunk floor carpet over the spare tire well (2) in the luggage compartment.
3. If equipped, reinstall the cargo liner and/or cargo net into the luggage compartment.
