Charger V8-5.7L (2008)
1. Engage the locator tab (2) on the back of the upper trim (4) into the locator hole on the inside of the B-pillar (3).
2. Align the two spring clip retainers on the trim with the slots in the inner B-pillar.
3. Using hand pressure, press firmly and evenly on the trim over each of the spring clip locations until the retainers snap into place.
4. Install and tighten the screw (1) that secures the lower end of the upper trim to the inside of the B-pillar. Tighten the screw to 3 Nm (25 in. lbs.).
5. Position the seat belt (4) and turning loop to the height adjuster on the upper B-pillar (2). Be certain that the webbing is not twisted.
6. Install and tighten the screw (1) that secures the turning loop to the seat belt height adjuster on the upper B-pillar. Tighten the screw to 40 Nm (30
ft. lbs.).
7. Position the trim cover (3) over the seat belt turning loop on the inside of the upper B-pillar.
8. Using hand pressure, press the trim cover and turning loop together until the cover snaps into place.
9. Reinstall the lower trim onto the inside of the B-pillar. See: Pillar Trim/B-Pillar Trim.
Upper-Sedan
UPPER - SEDAN
