Charger V8-5.7L (2008)
6. While holding guide pins from turning, remove caliper guide pin bolts (1).
7. Remove brake caliper (3) from brake adapter (2) and pads.
Rear-Wheel-Drive
REAR-WHEEL-DRIVE
NOTE: Before proceeding, See: Service Precautions/Brakes - Caution.
1. Disconnect and isolate battery negative cable (2) from battery post.
2. Using a brake pedal holding tool, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this position will
isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
3. Raise and support vehicle. See: Maintenance/Vehicle Lifting/Service and Repair
4. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
