Charger V8-5.7L (2008)
isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
3. Raise and support vehicle. See: Maintenance/Vehicle Lifting/Service and Repair
4. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
5. Remove banjo bolt (4) connecting flexible brake hose (5) to caliper (1). There are two sealing washers (2, 3) (one one each side of hose fitting)
that will come off when bolt is removed. Discard these washers; use NEW washers upon installation.
CAUTION: When pushing pistons back into caliper bores, use only a trim stick as shown or other suitable soft tool. Never use a
screwdriver or other metal pry bar due to potential damage to braking surface of rotor, caliper, pistons or dust boots.
6. Place trim stick (4) between brake pad (2) and outer edge of rotor (3).
7. Using trim stick, slowly apply pressure against brake pad (2) until both pistons (on that side of caliper) are completely bottomed in bores of caliper
half.
